Adafruit.io WipperSnapper Adds No-Code Support for the AM2301B – Temperature and Humidity Sensor

You now can use the AM2301B – Wired Enclosed AHT20 – Temperature and Humidity Sensor with Adafruit.io WipperSnapper for temperature and humidity measurements, without the need for writing a single line of code! 

More about the AM2301B:

The AM2301B is a nice but inexpensive temperature and humidity sensor from the same folks that brought us the AM2302. In fact, this enclosed sensor looks an awful lot like the popular DHT22/AM2302 temperature and humidity sensors, but unlike classic DHT sensors, it has an I²C interface! This sensor has a typical accuracy of ±2% relative humidity, and ±0.3 °C at 20-80% RH and 20-60 °C. There is only one I2C address so it’s not a good option when you need multiple humidity sensors.

What is WipperSnapper?

With Adafruit.IO and WipperSnapper Firmware, you can effortlessly connect various components and sensors to any of the 20+ supported development boards to build an internet-connected electronics project. The best part is that you can configure and control these sensors from the web using Adafruit IO, all without the need for programming.

Read this guide for instructions on using a device WipperSnapper with the AM2301B Sensor (same as AHT20) >>>