A new guide in the Adafruit Learning System – No-Code WipperSnapper Water Detection
Is there a leak in the basement? Did a pipe burst? Is the AC dripping? Before you run down to check, what if instead you received an alert on your phone? Using an Adafruit FunHouse, a water sensor, and WipperSnapper, this can be accomplished in minutes (and with no coding)!
In this guide, we’ll set up a water sensor inside Adafruit’s factory. In the AC (Air Conditioning) room, the units drip lots of water in the summertime. We’ll place our water sensor and FunHouse inside the room under one of the units, then if the floor is ever wet, the facilities team will get an email notification alerting the presence of water. This will help prevent water damage before it’s too late. And it can be done without a single line of code thanks to WipperSnapper and AdafruitIO.